BIS Certification For Stainless Steel Sliding Door Bolts (Aldrops) For Use With Padlocks IS 15834
Door ALdrops are fitted at the
door and can be used to the both side of the door used to close or open the
door. It is a mechanical device which doesn't need any key just push or
slide the AL drops in its place to close or release to open the door. These sliding door
bolts are installed on doors to facilitate smooth and friction-free movement.
Properties of Stainless Steel
- Corrosion
resistant.
- High
tensile strength.
- Very
durable.
- Temperature
resistant.
- Easy
formability and fabrication.
- Low-maintenance
(long lasting)
- Attractive
appearance.
- Environmentally
friendly (recyclable)
BIS is a statutory
institution established under the Bureau of Indian Standards Act, 1986 to promote harmonious development of the
activities of standardization, marking and quality certification of goods
and attending to connected matters in the country.
Stainless Steel Sliding door
bolts (ALdrops) for Use with Padlocks product
has been specified in IS 15834 : 2020 by
Bureau of Indian Standards.
SCOPE
This standard specifies the
requirements regarding materials, manufacture, dimensions and finish of clip
type stainless steel sliding door bolts used in general building construction
for locking doors, gates, etc., with padlocks.
REFERENCES
The standards given below contain
provisions which through reference in this text, constitute provisions of this
standard. At the time of publications, the editions indicated were valid. All
standards are subject to revision and parties to agreements based on this
standard are encouraged to investigate the possibility of applying the most
recent editions of the standards indicated below:
1608 (Part 1) : 2018/ISO 6892-1 : 2016 Metallic
materials - tensile testing: Part 1 Method of test at room temperature (fourth
revision)
4905 : 2015/ISO 24153 : 2019
Random Sampling and Randomization Procedures (first revision)
6527 : 1995 Stainless steel wire
rods - Specification (first revision)
6911 : 2017 Stainless steel
plate, sheet and strip - Specification (second revision)
9844 : 1981 Method of testing
corrosion resistance of electroplated and anodized aluminum coating by neutral
salt spray test
Raw Material :
Sheet – Clause 4.1 of IS 15834: 2020
Bolt – Clause 4.2 of IS 15834: 2020
Possible Tests in a Day :
i) Manufacture (Clause 6)
ii) Dimensions (Clause 5)
Following are the Testing Parameters :
·
Sheet
·
Bolt
·
Dimension
·
Tolerances
·
Manufacture
·
Finish
·
Tensile
Test
·
Corrosion
Resistance
BIS
Certification in India
It is always better to consult with experience team such as ERCS Pvt. Ltd. for smooth certification process.
For more information, please feel free to contact us at info@elitasrcs.com or call at +91-9076611770 / +91-9076611766.
